Below are instructions for adjusting the angle a 42" or larger touchscreen using the Peerless Stand. For full assembly instructions, see the following link: Peerless Stand Setup Instructions.


Step 1 - Loosen Bolts

Loosen the bolts indicated below. The left bolt in the image below must be fully removed, the bolt to the right needs only to be loosened. Repeat for both sides of the stand:

Step 2 - Adjust Angle

Pull the touchscreen down until it is at the desired angle, then tighten both bolts into place:

Please Note: The ideal angle will put the left screw in the middle hole (4 of 7)

Need additional help? Contact us at support@wondersign.com or Chat with us directly from within the my.catalogkiosk.com platform.

Did this answer your question?