If the kiosk is not running smoothly, follow the below steps to resolve the issue. Please note, these steps are for diagnosing issues on the Catalog Kiosk running on a 42" or larger Touchscreen.

Quick Links

Check Cables for Proper Connectivity

Step 1

Access the Chromebox that is connected to the ELO touchscreen, which is typically located in the kiosk stand.

Step 2

Ensure the following cables are secured in the back of the Chromebox:

  1. Power
  2. Ethernet (if using WiFi, no cable will be attached)
  3. USB
  4. HDMI

Step 3

Remove the cable cover located on the back right side of the monitor to access the touchscreen’s connector panel. Once removed, ensure the USB cable from the Chromebox connects to the "Touch USB" port in the back of the touchscreen. Follow the same process for the HDMI cable running from the Chromebox to the touchscreen.

The ports used in the back of the touchscreen are indicated below. Please Note: The HDMI & Touch USB ports connect to the Chromebox. The AC Power In connects to an electrical outlet:

Step 4

Return to touchscreen to ensure kiosk is functioning properly. If not, continue to the next troubleshooting process below.

Wipe and Re-Enroll the Chromebox

Parts Required

To resolve this issue, the Chromebox needs to wiped (factory reset) & reenrolled. Before starting, gather the following parts:

  1. USB Keyboard
  2.  Paperclip

Step 1

Turn off the Chromebox by holding the power button down for 5 seconds. When complete the power light will be off.

Step 2

Connect a USB Keyboard to the front of the Chromebox, and put a paperclip into the recovery button hole:

Step 3

Press down the recovery button with the paperclip while turning on the Chromebox

Please Note: the image above is for an Asus brand Chromebox. The power button may look slightly different with a different model, but will be located on front or top of the Chromebox

Step 4

As the screen boots up, a yellow exclamation point will appear. Press Ctrl + D on the keyboard

Step 5

When the below screen appears, press the recovery button with the paperclip again:

Step 6

When the below screen appears, press the spacebar on the keyboard, then press Enter to confirm

Step 7

Once Enter is pressed, the below screen will appear, and the Chromebox will reboot

Step 8

Once powered on, the Chromebox will display the first setup screen. Press the Tab key on the keyboard to navigate to the "Select a Network" section. After configuring your WiFi connection, tap on "Continue":

Please Note: If you are using a wired LAN connection, there is no need to choose a WIFi network; the Chromebox will connect automatically

Step 9

Please read the Google OS Terms carefully, and then hit “Accept and Continue”

Step 10

On the login screen appears (see below), press Ctrl + Alt + E on the keyboard to switch to the “Enterprise Enrollment” screen

Step 11

Once on the Enterprise Enrollment Screen, enter the login credentials for Ashley Catalog Kiosk

Login Credentials

User Name: catk-enroll@wondersign.com

Password: wondersign

Step 12

After successful enrollment, the below screen will appear. Press Enter to proceed

Step 13

The Chromebox will automatically install and launch the Catalog Kiosk application

Step 14

The Kiosk’s “Attractor Screen” will now be displayed, and the Kiosk should be fully operational.

Did this answer your question?